Lexus 2005 IS300 User Manual page 522

BO-124
3 Clips
Machmarks
2005 LEXUS IS300 (RM1140U)
BODY - BACK DOOR GLASS
HINT:
Confirm that the moulding is attached to the body panel as
shown in the illustration.
(d) Hold the back door glass in place securely with a protec-
tive tape or equivalent until the adhesive hardens.
NOTICE:
Take care not to drive the vehicle during the time described
in the table below.
H05630
Temperature
35°C (95°F)
20°C (68°F)
5°C (41°F)
9. INSPECT FOR LEAK AND REPAIR
(a) Conduct a leak test after the hardening time has elapsed.
(b) Seal any leak with sealant.
Part No. 08833-00030 or equivalent.
10. INSTALL REAR SPOILER COVER
Install the rear spoiler cover with the 3 nuts.
11. INSTALL BACK DOOR OUTSIDE HANDLE
H19013
12. INSTALL REAR WIPER MOTOR
(a) Install the rear wiper motor with the 3 bolts.
Torque: 5.5 N·m (56 kgf·cm, 49 in.·lbf)
(b) Connect the connector.
(c) Install the nut and washer on the outer side of the back
door panel.
Torque: 12 N·m (122 kgf·cm, 9 ft·lbf)
H19059
13. INSTALL REAR WIPER ARM
(a) Install the wiper arm and tighten the nut by hand. Operate
the wiper once and turn the wiper switch OFF.
(b) Align the machmarks on the wiper arm and wiper motor.
(c) Install the rear wiper arm with the nut.
Torque: 5.5 N·m (56 kgf·cm, 49 in.·lbf)
(d) Install the wiper arm cover.
H19208
Minimum time prior to driving the vehicle
Author : Date :
1.5 hours
5 hours
24 hours
2361