AT-10
Clamp
2005 LEXUS IS300 (RM1140U)
AUTOMATIC TRANSMISSION
6.
Remove the magnets and use them to collect steel particles.
Carefully look at the foreign matter and particles in the pan and
on the magnets to anticipate the type of wear you will find in the
transmission.
Steel (magnetic) ... bearing, gear and clutch plate wear
Brass (non-magnetic) ... bushing wear
AT0103
7.
NOTICE:
Be careful as some fluid will come out of the oil strainer.
(a)
D09388
(b)
D00753
8.
(a)
(b)
(c)
D09389
(d)
9.
(a)
D00916
-
ATF TEMPERATURE SENSOR
EXAMINE PARTICLES IN PAN
REMOVE OIL STRAINER
Remove the 4 bolts and oil strainer.
Remove the 3 gaskets from the oil strainer.
REMOVE SOLENOID WIRING WITH ATF TEMPERA-
TURE SENSOR
Disconnect the ATF temperature sensor and remove the
O-ring.
Remove the bolt and clamp.
Disconnect the 7 connectors from the solenoid valves.
Remove the bolt, solenoid connector and O-ring.
INSTALL SOLENOID WIRING WITH ATF TEMPERA-
TURE SENSOR
Install the solenoid connector and a new O-ring with the
bolt.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
Author :
Date :
1632