Memory Call System Using A Wireless Remote Control Key; Registering The Wireless Remote Control Key Id Code - Lexus 2004 LS430 Owner's Manual

OCCUPANT RESTRAINT SYSTEMS
MEMORY CALL SYSTEM USING A WIRELESS REMOTE
CONTROL KEY
This system allows you to adjust the driver's seat, the
driver's head restraint height, driver's seat cushion
length, the height of the shoulder belt anchor of the
driver's seat belt and outside rear view mirrors to the
memorized position when you open the driver's door after
unlocking it with a wireless remote control key. And when
you insert the key into the ignition switch, the tilt and
telescopic steering is adjusted.
To activate this system, the ID of the wireless remote
control key needs to be registered in the memory button.
Registering the wireless remote control key
ID code
Before the registration of the ID of the wireless remote control
key, the driving position must be memorized in the memory
button.
When registering, the driver's door must be closed with the
ignition switch in the "OFF" position.
1. Keep the wireless remote control key in possession,
select a button in which you want to record the ID of the
key from buttons "1", "2" and "3" and push it.
2. Push the "LOCK" or "UNLOCK" button on the wireless
remote control key for about one second with button "1",
"2" or "3" held down.
222
When the registration is completed, one beep sounds. If the
key has already been registered, the previous memory will be
erased. If the same driving position profile for the same key is
registered in another button, that memory will also be erased.
CAUTION
Do not push the "LOCK" button any longer than 2 or 3
seconds. Pushing the button longer activates an alarm.
For details, see page 40.
Erasing the previous registration memory
The driver's door must be closed with the ignition switch in the
"OFF" position.
1. Keep the wireless remote control key in which you want
to cancel the registration in possession and push the
"SET" button.
2. Push the "LOCK" or "UNLOCK" button on the wireless
remote control key for about one second with the "SET"
button held down.
When the previous key ID memory is erased, two beeps
sound.