Lexus 2005 IS300 User Manual page 487

Adhesive
5.0 mm
(0.197 in.)
Adhesive
Primer M
2005 LEXUS IS300 (RM1140U)
4.
(a)
HINT:
After cutting off the tip, finish off adhesive within the time de-
scribed in the chart below.
B
(b)
(c)
5.0 mm
(0.197 in.)
HINT:
H10546
When removing the moulding, apply adhesive throughly to the
part where the body sealer is removed.
5.
Push the moulding to the body.
NOTICE:
F
F
F
F
BODY - ROOF DRIP SIDE FINISH MOULDING (Sedan)
APPLY ADHESIVE
Cut off the tip of the cartridge nozzle.
Part No. 08850-00801 or equivalent
Temperature
35 °C (95 °F)
20 °C (68 °F)
5 °C (41 °F)
Load the cartridge into the sealer gun.
Apply adhesive to the hatched area in the illustration for
both front and rear of the vehicle.
Front end:
B: 30 mm (1.18 in.)
Rear end:
B: 25 mm (0.98 in.)
INSTALL MOULDING
Make sure that the body and moulding are heated to
the proper temperature.
Do not depress the adhesive coated parts excessive-
ly but just hold them down with your thumb.
Scrape off any overflowing adhesive with a plastic
spatula and clean the surface with a dry rag.
Take care not to drive the vehicle during the time de-
scribed in the chart below.
Temperature
35 °C (95 °F)
20 °C (68 °F)
5 °C (41 °F)
Author :
Tackfree time
15 minutes
100 minutes
8 hours
Minimum time prior to driving the vehicle
1.5 hours
5 hours
24 hours
Date :
BO-89
2326