For Vehicles Equipped With Vehicle Skid Control (Vsc) System - Lexus 2005 IS300 User Manual

2005 LEXUS IS300 (RM1140U)
INTRODUCTION - FOR ALL OF VEHICLES
(a) Press the TRAC cut switch.
(b) Check that the TRAC system is turned OFF by the TRAC
cut switch.
HINT:
The SLIP indicator light should be always ON immediately after
the engine is restarted.
F12327
(c) Begin measurements.
(d) Press the TRAC cut switch to turn the TRAC to the opera-
tive mode and check that the TRAC OFF indicator light
goes off.
HINT:
The SLIP indicator light blinks when the TRAC system is opera-
tional.
B07101
6. FOR VEHICLES EQUIPPED WITH VEHICLE SKID
CONTROL (VSC) SYSTEM
NOTICE:
When using 2-wheel drum tester such as a speedometer
tester or chassis dynamometer, etc., or jacking up the front
wheels and driving the wheels, always push in the VSC
OFF switch to turn the VSC system OFF.
(a) Press the VSC OFF switch.
(b) Check that the VSC OFF indicator light comes ON.
HINT:
The VSC OFF indicator light should be always OFF when the
engine is restarted.
B15256
(c) Begin measurements.
(d) Press the VSC OFF switch again to change the VSC sys-
tem to operational condition and check that the VSC OFF
indicator light goes off.
HINT:
The SLIP indicator light blinks and the VSC buzzer sounds
when the VSC system is operational.
B07101
Author : Date :
IN-19
19