The selected Drill Size is displayed along with its decimal Inch
equivalent. If the entered value doesn't match a Drill Size, the next
smaller size is displayed. You can toggle through the available
sizes in increasing order with either the
key displays the available sizes in decreasing order. To set the
-
displayed Drill Size, press
Numeric Drill Size entry
Enter a #36 Drill and toggle through the next larger available
sizes:
KeySTROKe
O O
1. Enter the Drill Size:
36D
2. Display the next larger available sizes:
D
D
*
D
* Repeated presses of
and
keys will toggle forward and backward, respectively, through all
-
available Drill Sizes.
Letter Drill Size entry
You can enter letter Drill Sizes by selecting an alphabet character
via Alpha Mode (
desired letter can be selected by toggling through Alpha Mode
until the letter is reached or by specifying the numerical order of
the letter within the alphabet prior to entering Alpha Mode. Both
methods are shown below.
Select Drill Size E by toggling though Alpha Mode. Then, select
Drill Size G by entering the numerical order of the letter (the letter
G is 7th in the alphabet).
(or any other key).
O
2_75
display the next larger Drill Sizes. The
D
) and then storing it using the
g8
key or the
D
36
DRILL SIZe
MM DRILL SIZe
7/64
DRILL SIZe
35
DRILL SIZe
U
ser
key. The
+
DISPLAy
0.
0.1065
$
INCH
0.1083
$
INCH
0.1094
$
INCH
$
0.1100
INCH
+
key. The
D
(cont'd)
'
G
— 37
s
Uide