Tenda D301 User Manual page 21

assigns you a static (fixed) IP
address, IP subnet mask and the
gateway IP address, you need to
select the IP over Ethernet (IPoE).
IPoA
Bridging
_________________________________________________________________________________________________
Tip:
For PPPoE, IPoE, and Bridging Internet connection types, you must first select EoA on the ATM Interface Screen, for
more information, see To set up the ATM
_________________________________________________________________________________________________
PPP over Ethernet (PPPoE)
If you have selected the
EoA
you click the WAN Service tab, select the configured interface and click Next.
Select PPPoE.
1.
Edit the Enter Service Description. This field is optional. We recommend that you keep the default.
2.
Select a network protocol: IPv4, IPv6 or IPv4 & IPv6 (dual stack).
3.
Click Next.
4.
_________________________________________________________________________________________________
Note:
If you select IPv6 or IPv4 & IPv6 (dual stack), skip to
_________________________________________________________________________________________________
Static (Fixed) IP
interface.
from the ATM Interface screen in Layer2 Interface, you will see the screen below when
IPv6
available, enter it also.
Enter the assigned IP address, subnet mask, and the IP address of
your ISP's primary DNS server. This information should have been
provided to you by your ISP. If a secondary DNS server address is
available, enter it also.
If you wish to iniate a dialup directly from your PC for Internet
access or enjoy the entire Internet connection (instead of sharing it
with others), you can select the Bridging and then click Next.
.
- 21 -
Wireless Modem Router User Guide