Tenda D301 User Manual page 22

PPP User Name: This is for logging in to your ISP. If you cannot locate this information, ask your ISP to provide

it.
PPP Password: This is for logging in to your ISP. If you cannot locate this information, ask your ISP to provide it.

PPPoE Service Name: This information is provided by your ISP. Only enter it if instructed by your ISP.

Authentication Method: This is used by ISP to authenticate the client that attempts to connect. If you are not sure,

consult your ISP or select Auto.
Clone MAC: Clicking this button copies the MAC address of your PC to the router. Many broadband ISPs restrict

access by allowing traffic only from the MAC address of your broadband modem, but some ISPs additionally
register the MAC address of the network interface card in your computer when your account is first opened. They
then accept traffic only from the MAC address of that computer. If so, configure your router to "clone" the MAC
address from the authorized computer.
Dial on demand: Connect to ISP only when there is traffic transmission. This saves your broadband Internet

service bill.
PPP IP extension: If enabled, all the IP addresses in outgoing packets including management packets on the WAN

port will be changed to the device's WAN IP address. Only change the default settings if necessary.
Enable PPP Debug Mode: Only enable this feature if supported by your ISP.

Bridge PPPoE Frames Between WAN and Local Ports: If enabled, PPPoE dialup frame from LAN side will

directly egress the WAN port without modification.
Multicast Proxy: If enabled, the router will use multicast proxy.

IPv6
If you select IPv4 as the network protocol, skip this section.
- 22 -
Wireless Modem Router User Guide