Tenda D301 User Manual page 12

Depending on the type of connection, you are prompted to enter your ISP settings, as shown in the following table:
Internet Connection Type
PPPoE
PPPoA
Dynamic IP
IPoE
Static (Fixed) IP
IPoA Static (Fixed) IP
_________________________________________________________________________________________________
Note:
If your country and/or your ISP are not covered on the home page, please click the
home page and then select Advanced Setup -> Layer2 Interface -> ATM Interface and then click Add there to manually
configure the VPI and VCI. If you cannot locate this information, refer to
provide it. For more information, see
_________________________________________________________________________________________________
e. After you configure all the above settings, click OK to save and apply them.
f. Test Internet Connectivity
Launch a web browser and enter www.tendacn.com. If the webpage is opened, you are connected to Internet.
ISP Information
Enter the ISP login user name and password. If you cannot locate this information, ask your ISP
to provide it.
No entries are needed.
Enter the assigned IP address, subnet mask, and the IP address of your ISP's primary DNS
server. This information should have been provided to you by your ISP. If a secondary DNS
server address is available, enter it also.
Enter the assigned IP address, subnet mask, and the IP address of your ISP's primary DNS
server. This information should have been provided to you by your ISP. If a secondary DNS
server address is available, enter it also.
To set up the ATM interface
Appendix 4 VPI/VCI List
and To setup WAN Service for ATM
- 12 -
Wireless Modem Router User Guide
button on the
or ask your ISP to
Interface.