Tenda D301 User Manual page 31

PPP User Name: This is for logging in to your ISP. If you cannot locate this information, ask your ISP to provide

it.
PPP Password: This is for logging in to your ISP. If you cannot locate this information, ask your ISP to provide it.

Authentication Method: This is used by ISP to authenticate the client that attempts to connect. If you are not sure,

consult your ISP or select Auto.
Dial on demand: Connect to ISP only when there is traffic transmission. This saves your broadband Internet

service bill.
Enable PPP Debug Mode: Only enable this feature if supported by your ISP.

Bridge PPPoE Frames Between WAN and Local Ports: If enabled, PPPoE dialup frame from LAN side will

directly egress the WAN port without modification.
Multicast Proxy: If enabled, the router will use multicast proxy.

If you are not sure about the options on this screen, simply enter your ISP user name and password and leave the other
options unchanged from defaults. Click
WAN gateway
Here you can configure the WAN gateway address. After you configure it click Next. The default setting is
recommended.
_________________________________________________________________________________________________
Note:
Default gateway interface list can have multiple WAN interfaces served as system default gateways but only one will be
used according to the priority with the first being the higest and the last one the lowest priority if the WAN interface is
connected. Priority order
_________________________________________________________________________________________________
to enter the following screen.
Next
can be changed by
- 31 -
removing all and adding
Wireless Modem Router User Guide
them back in again.