Quick Oil Drain System - Bayliner Classic Runabouts Owner's Manual

Chapter 4: Propulsion & Related Systems

Quick Oil Drain System

The quick oil drain hose assembly was attached to the engine oil pan at the factory. However, some minor assembly
is still needed before you can use this system.
NOTE: This is not the only method for changing your oil. Your selling dealer can recommend other methods.
How to install the quick oil drain system:
1. Unscrew the factory installed
bilge plug from the bilge
drain (A). NOTE: Keep the
original factory bilge plug on
your boat as a spare.
2. Unclip the quick oil drain
assembly from the wire loop
(B) on the engine.
3. Unclip the bilge plug's draw
cord (C) from the oil drain
plug's draw cord (D).
4. Thread the oil drain plug's
draw cord (D) through the
bilge drain (A).
5. Pull the oil drain plug (E),
and the oil drain hose (F)
through the bilge drain.
6. Adjust the hose stop clamp
(G) so that no more than 12
inches of hose, including the
oil drain plug, can extend out
of the bilge drain (A).
7. Clip the bilge plug's draw
cord (C) back to the oil drain
plug's draw cord (D).
8. Push the oil drain hose, oil
drain plug, and both draw
cords through the bilge drain
and into the bilge area.
9. Screw the bilge plug (H) into
the bilge drain (A) and
tighten firmly.
To drain the engine oil:
1. Remove your boat from the water.
2. Unscrew the bilge plug.
3. Pull the draw cord until the oil drain plug and the oil drain hose slide out of the bilge drain.
4. Place the end of the oil drain hose into a suitable container.
5. Unscrew the oil drain plug and drain the engine oil.
6. Replace the oil drain plug.
7. Push the drain hose back into the bilge.
8. Replace the bilge plug and tighten firmly.
Always dispose of waste oil in accordance with local regulations.
32
QUICK OIL DRAIN SYSTEM
TRANSOM
D
C
H
BILGE
A
G
B
C
D
Classic Runabouts • Owner's Manual Supplement
ENGINE
OIL PAN
F
E
FACTORY
INSTALLED