Livewell System (194 Only) - Bayliner Classic Runabouts Owner's Manual

Classic Runabouts • Owner's Manual Supplement

Livewell System (194 Only)

FLOODING and SWAMPING HAZARD!
• NEVER leave your boat unattended while the livewell system is running.
• Any leak or break in this system may allow large amounts of water to flood the bilge, which
could swamp the battery(s), and even sink your boat.
SYSTEM DAMAGE HAZARD!
BEFORE turning On the livewell system, make sure the intake seacock is Open.
Filling & Using the Livewell
1. Insert the standpipe into
the drain fitting at the bot-
tom of the tank.
2. On the switch panel, turn
On the livewell pump (for
the location of the livewell
pump switch, see the
Component Locations sec-
tion in Chapter 2 of this
supplement).
• Remove the standpipe to
drain the livewell.
Troubleshooting
If you followed the instruc-
tions in steps 1 and 2 above,
but water does not pump into
the tank, possible causes are:
• A hose is collapsed or there
is clogging debris in the
system.
• The livewell fuse is blown.
Aeration Tips
The level of aeration is con-
trolled by the aerator control
valve.
• In clean open water little or
no aeration may be needed.
• In brackish back waters a
higher level of aeration
may be needed.
! WARNING!
! CAUTION
TO THRU-
HULL DRAIN
STANDPIPE
REMOVED
AERATOR
VALVE
STANDPIPE
ATTACHED
Chapter 6: Plumbing
LIVEWELL
DRAIN
AERATOR
VALVE
THRU-HULL
AERATOR
PUMP
37