Quick Oil Drain System - Bayliner VR5 Owner's Manual

Chapter 3: Propulsion and Related Systems

Quick Oil Drain System

The quick oil drain hose assembly was attached to the engine oil pan at the factory. However, some minor
assembly is still needed before you can use this system.
NOTE: This is not the only method for changing your oil. Your selling dealer can recommend other methods.
How to install the quick oil drain system:
1. Unscrew the factory installed bilge
plug from the garboard drain (A).
NOTE: Keep the original factory
bilge plug on your boat as a spare.
2. Unclip the quick oil drain
assembly from the wire loop (B)
on the engine.
3. Unclip the bilge plug's draw cord
(C) from the oil drain plug's draw
cord (D).
4. Thread the oil drain plug's draw
cord (D) through the garboard
drain (A).
5. Pull the oil drain plug (E), and
the oil drain hose (F) through the
garboard drain.
6. Adjust the hose stop clamp (G)
so that no more than 12 inches of
hose, including the oil drain plug,
can extend out of the garboard
drain (A).
7. Clip the bilge plug's draw cord (C)
back to the oil drain plug's draw
cord (D).
8. Push the oil drain hose, oil drain
plug, and both draw cords through the garboard drain and into the bilge area.
9. Screw the bilge plug (H) into the garboard drain (A) and tighten firmly.
To drain the engine oil:
1. Remove your boat from the water.
2. Unscrew the bilge plug.
3. Pull the draw cord until the oil drain plug and the oil drain hose slide out of the garboard drain.
4. Place the end of the oil drain hose into a suitable container.
5. Unscrew the oil drain plug and drain the engine oil.
6. Replace the oil drain plug.
7. Push the drain hose back into the bilge.
8. Replace the bilge plug and tighten firmly.
Always dispose of waste oil in accordance with local laws.
Supplement
26