Network And Interface Commands; Push Messages - Cisco TelePresence PrecisionHD 1080P 12x User Manual

Cisco TelePresence PrecisionHD Camera
Contents Introduction
The VISCA™/RS–232 control protocol, cont...

Network and interface commands

Command set Command
packet
IF_Clear 8x 01 00 01 ff
Address_Set 8x 30 0p ff
Command_Cancel 8x 2p ff
*
D14640.03 PrecisionHD 1080p-720p Camera User Guide TC4.0, November 2010.
© 2010 Cisco Systems, Inc. All rights reserved.
The physical interface Connecting the camera
Comments
Clear command buffer. Stop any current
operation in progress.
p = address for this device. If x=8 (broadcast),
increase p with 1 before sending to chain.
p = Socket ID. PrecisionHD 1080p 12X does
not support multiple sockets. Commands will
always run to completion. Don't use it.
Video output formats
INFO: Some VISCA™ commands do not apply to the PrecisionHD 1080p 4X camera.

Push messages

Messages sent from camera to controller.
Command set Command packet
Network_Change y0 38 ff
IR_Push y0 07 7d 02 gg hh ff
*
Do not apply to PrecisionHD 4X camera
21
PrecisionHD Camera User guide
Daisy chaning Appendices Appendices
Reply and comments
This indicates that cameras have been
added to or removed from the chain.
It is recommended to wait 9 seconds after
receiving this message before doing a full
reconfigure.
If IR mode is on, IR codes received by the
camera will be sent to the controller.
gg = IR ID
hh = keycode
www.cisco.com