User Servicing Instructions - Honeywell HY-200 Series Owner's Manual

14. Do not hang or mount fan on a wall
or ceiling.
15. Do not operate if the fan housing is damaged.
16. A loose fit between the AC outlet (receptacle)
and plug may cause overheating and a
distortion of the plug. Contact a qualified
electrician to replace loose or worn outlet.
17. Do not operate any fan with a damaged cord
or plug. Discard any damaged fan, return
the fan to the retailer where the fan was
purchased, or request a return authorization
to return to Kaz USA, Inc. for examination
and/or repair.
FUSED SAFETY PLUG - FOR US ONLY
Thank you for your purchase.
This fan features a fused safety plug which is designed to cut off electric current to the fan if an
electrical fault occurs. Please see below for more information on how to properly use your fan and
replace the safety plug fuse, if needed.

USER SERVICING INSTRUCTIONS

• Grasp plug and remove from the receptacle or other outlet device.
Do not unplug by pulling on cord.
• If your fan loses power and you suspect that the fuse on your fan has
blown, you should first remove the spare fuse holder attached to the
cord plug (Fig. 1). Remove the spare fuse from the plastic spare fuse
holder, and set the spare fuse aside (Fig. 2).
• You can gain access to the blown fuse by sliding open the door
found on the side of the plug. Slide the door outward until the blown
fuse is fully visible (Fig. 3).
• Carefully remove the blown fuse and snap the replacement fuse into
place. Risk of fire. Replace fuse only with 2.5 Amp, 125 volt fuse
(provided with product). Fully close the fuse door by sliding back
into place. Discard the blown fuse. The plug should now be ready for
normal use.
• Risk of fire. Do not replace attached plug. Contains a safety device
(fuse) that should not be removed. Discard product if the attached
plug is damaged.
• If you need further information on how or when to replace the fuse in
the safety plug, please contact Kaz Consumer Relations Department
by visiting our website at www.HoneywellFanSavings.com or calling
1-800-477-0457.
18. Do not run fan cord under carpeting. Do
not cover cord with throw rugs, runners, or
similar coverings. Do not route cord under
furniture or appliances. Arrange cord away
from traffic areas and where it will not be
tripped over.
WARNING: To Reduce The Risk of Fire or
Electric Shock, Do Not Use This Fan With
Any Solid-State Speed Control Device,
other than the one supplied.
- 2 -
Fig. 1
Fig. 2
Fig. 3