Table of Contents
Advertisement
2-2 Connector Panel
3 Remote input/output section
1 RS232C connector
2 REMOTE1-IN connector
3 REMOTE 2 PARALLEL I/O connector
4 VIDEO CONTROL connector
5 REMOTE1-I/O connectors
REMOTE 2 PARALLEL I/O(50P)
REMOTE 1-IN(9P)
RS232C
ETHERNET
USB
6 USB connector
7 ETHERNET connector
1 RS232C connector (RS-232C serial interface)
(D-sub 9-pin)
This is used for manufacturing and services.
2 REMOTE 1-IN (9P) connector
Use this, with the supplied 9-pin remote control cable,
to connect the unit to another SRW-5000 unit or
another HD VTR unit to carry out editing with a BVE-
series editor BVE-900/910/2000/9000/9100.
3 REMOTE 2 PARALLEL I/O connector (D-sub
50-pin)
Inputs an external remote control signal.
For details, refer to the Maintenance Manual Volume 1.
4 VIDEO CONTROL (Digital Video Processor
Control) connector (D-sub 9-pin)
Connects to the optional HKDV-503 HD Digital Video
Controller to enable remote control of the internal
digital video processor. Turn off the power before
connecting the remote controller.
2-16
Chapter 2 Locations and Functions of Parts
REMOTE 1-I/O(9P)
VIDEO CONROL
5 REMOTE 1-I/O (9P) connectors
(D-sub 9-pin)
Use this, with the supplied 9-pin remote control cable,
to connect the unit to another SRW-5000 unit or
another HD VTR unit to carry out editing with a BVE-
series editor BVE-900/2000/9000/9100.
6 USB connector
This is used for manufacturing and services.
7 ETHERNET connector
Used for monitoring the VTR by SNMP, or for setting
or changing VTR settings by HTTP.
Caution
When using a modular ETHERNET connector
For safety, do not connect to the connector for
peripheral device wiring that might have excessive
voltage.
4 Power supply
AC IN
-AC IN connector
-AC IN connector (3-pin)
Connects to an AC outlet using an appropriate power
cord.
Advertisement
Table of Contents
