Sony SVR-3000 Upgrade Instructions

TIVO UPGRADE INSTRUCTIONS
(c) 2001-2003, Adberg Consulting LLC. All rights reserved.
Instructions for replace drive upgrade for Sony SVR-3000
A FEW WORDS OF CAUTION:
First and foremost, please be aware that upgrading a TiVo presents a few physical hazards. As
with most consumer electronics devices, components in the TiVo may still carry a lethal charge,
even after disconnecting from your power supply. Be aware of this while working inside your TiVo.
Allow sufficient time for discharging of components and avoid contact as much as possible with
potential hazards. While we have done everything we can to provide accurate, easy-to-follow
instructions, we cannot be responsible for any damage done to your TiVo or to yourself as a result
of your upgrade. By opening your TiVo, you agree that neither Adberg Consulting LLC nor any of its
members or affiliates is responsible in any way for any harm done. Please be VERY careful when
upgrading. NEVER open the TiVo while the unit is plugged in and NEVER operate the TiVo if the lid
is not securely fastened.
Please Note: Opening the TiVo voids the
1. OPENING THE TIVO
1.1. Unplug the power cord from the TiVo and wait five minutes for the TiVo to
discharge. Do not plug the TiVo back in until you are completely finished. Be very careful
of static electricity, which can destroy your TiVo's internal parts. You shouldn't perform
this upgrade on carpet.
1.2. Using a Philips-head screwdriver, unscrew the four screws on the back of
your TiVo. The four screws are surrounded by silver from the top of the TiVo's.
1.3. Next, remove the four, large-head screws, two on each side of the unit.
1.4. Once the eight screws are removed, you have to remove the lid, which can
sometimes be difficult. The WeaKnees.com "tried and true" method is to place the TiVo on
the floor and kneel down with your knees about 6 inches from the FRONT of the TiVo.
Place your palms on the top side edges of the TiVo, toward the back and push toward the
back of the TiVo (this occasionally requires a bit of force). The cover should slide back and
then up. Remove the cover from the TiVo, and set it in front of the TiVo unit, top up. You
will use this as a platform for the drive bay.
warranty.
http://www.weaknees.com/
WeaKnees.com