Changing The Source Name; Selecting Different Sources For Picture And Sound - JVC RX-5032VSL Instructions Manual

Basic Operations
Front panel
STANDBY
SURROUND
STANDBY/ON
DSP
DIGITAL AUTO
ANALOG
LINEAR PCM
SURROUND/DSP DIGITAL
OFF
DVD MULTI DVD
D I G I T A L
D I G I T A L
S U R R O U N D P R O L O G I C
ON/OFF
PHONES SPEAKERS
jack ON/OFF

Changing the Source Name

When you have connected a CD recorder to the TAPE/CDR
jacks on the rear panel, change the source name to CDR so
that "CDR" appears on the display when selected as the
source.
RX-6030VBK/RX-6032VSL
RX-5030VBK/RX-5032VSL
1
Press TAPE/CDR (SOURCE NAME) on the
front panel.
• Make sure "TAPE" appears on the display.
2
Press again and hold SOURCE NAME
(TAPE/CDR) on the front panel until
"ASSIGN CDR" appears on the display.
To change the source name from "CDR" to "TAPE," repeat
the same procedure above (in step 1 , make sure "CDR"
appears on the display).
Note:
Without changing the source name, you can still use the connected
components; however, you may experience one of the following
inconveniences:
• A different source name will appear on the display when you select
the target component.
• You cannot use the digital input (see page 16) for the CD recorder.
• You cannot use the COMPU LINK remote control system (see page
29) to operate the target component.
12
MASTER VOLUME
DIMMER
control
RX–6030V AUDIO/VIDEO CONTROL RECEIVER
INPUT DIGITAL
SPK 1 2 ONE TOUCH OPERATION BASS BOOST INPUT ATT EON RDS SLEEP
L C R PRO LOGIC DSP H.PHONE AUTO MUTING TUNED STEREO TA NEWS INFO VOLUME
S.WFR LFE
LS S RS
CH– INPUT ANALOG
INPUT ATT
VCR TV SOUND
FM/AM TUNING FM/AM RESET FM MODE MEMORY
SOURCE NAME Audio source
(TAPE/CDR) selection buttons
Remote
NOT
CD TAPE/CDR FM AM
SOURCE NAME
CD TAPE/CDR FM/AM
SOURCE NAME
Remote control
10
Audio source
selection
buttons
DIMMER
Selecting Different Sources for Picture
and Sound
You can watch the picture from a video component while
listening to sound from another component.
Press one of the audio source selection buttons while
watching the picture from a video component such as the
VCR or DVD player.
• Once you have selected a video source, pictures of the
selected source are sent to the TV until you select another
video source.
RX-6030VBK/RX-6032VSL
CD TAPE/CDR FM AM
SOURCE NAME
On the front panel
RX-5030VBK/RX-5032VSL
CD TAPE/CDR FM/AM
SOURCE NAME
On the front panel
0 10
TA/NEWS/INFO
DISPLAY MODE
MUTING
VOLUME +/–
TAPE/CDR CD DVD DVD MULTI
ANALOG
/DIGITAL
FM/AM TV SOUND VCR
From the remote control
TAPE/CDR CD DVD
ANALOG
FM/AM TV SOUND VCR /DIGITAL
From the remote control