Page 1
Test in compliance with EN 13240 Make a note of your stove’s product registration number here so that you have it available if you need to contact Version GB 27.11.07 - 1 The EC declaration of conformity is available from www.scan.dk...
(e.g. Leca, Plewa, before refuelling. Icopal, Isokern, Zanda etc.) The Scan Basic 4-2 & 4-2 K were build in compliance with the No matter whether an authorised Scan dealer installs your stove, or homologised product type specified in the Assembly and Instruction you do the job yourself, remember that the chimney sweep has to Manual provided with the product.
• Glove Side panels • Fire starters for first lighting Fitting the side panels for the Scan Basic 4-2 K, see below. • Springs for side panels (Scan Basic 4-2 K) Load bearing underlay All of the products in our portfolio are classified as light-duty firepla- ces;...
Page 4
Connection between stove and steel chimney Your Scan dealer, or local chimney sweep, can advise you on choosing a make and type of steel chimney. This ensures that the chimney will match your wood stove. As a general rule, the length of the flue should not be less than 3,5 m measured from the top of the wood-burning stove.
Page 5
I N S T R U C T I O N S F O R U S E CB Technology (Clean Burning) Smoke deflector plates Your wood-burning stove is fitted with CB technology. To ensure The smoke deflector plates are located in the upper part of the com- optimum burning of the gases released by the burning process, air bustion chamber.
We recommend the use of fire starters, or similar products, which tures inside and outside the chimney. The higher the temperature are available from your Scan dealer. Using fire starters helps to light difference is, the better the draft in the chimney will be. It is thus the wood quicker, and keeps the burning process clean.
You can easily remove this build up by cleaning with in the stove, and in the chimney. Burning moist wood also causes a dry cloth and glass cleaner. Your authorised Scan dealer stocks a pollution. special glass cleaner for this purpose.
• In case of repairs that do not comply with our instructions or instructions by an authorised Scan dealer. The surface of the stove is turning grey • In case of any manipulation of the original state of this Scan • Overheating (see instructions for heating) product or its accessories.