Extron electronics System 5 IP Series User Manual page 91

Command/response table for special function SIS commands, continued
Command
Miscellaneous settings
Enable switcher slaving
Set FPC lamp control 24
View/query button lamp control
This command yeilds a response of 0 if a button lighting combination other than the ones listed for
using the LX commands (shown on page 5-30). For example, the switcher responds with a status of 0 if the input 1
button is set to blink green slowly and red quickly at the same time.
All video out (blue screen defeat)
ASCII Command Response
(host to Syst. 5IP) (switcher to host)
*41 # Slave*
X? X?
* *51 # Lmp
X? Y? X?
*51 #
Y? X?
*52 # AllVidOut*
X?
System 5 IP • SIS
values
X?
and additional descriptions
For , 0 = disable (default),
X?
1 = enable slave control of an
Extron MPS 112CS switcher.
* is the LED state:
Y? X?
0 = all LEDs are off
1 = green LED is on
2 = red LED is on
3 = green & red LEDs are on
(button glows amber).
4 = green LED blinks slowly
5 = red LED blinks slowly
6 = green & red LEDs blink
amber slowly
7 = green LED blinks quickly
8 = red LED blinks quickly
9 = green & red LEDs blink
amber quickly
is which projector power or
Y?
room/function button to
control:
1 = power on button
2 = power off button
3 = room/function button 1
4 = room/function button 2
5 = room/function button 3
6 = room/function button 4.
This command disables/enables
X?
sending video signals out two
of the switcher's output ports
(composite video and RGB or
S-video and RGB) at all times.
Enable this feature for projector
models that must receive an
active signal at each of their
inputs in order to work
properly.
For ,
X?
0 = off/disable (default)
1 = on/enable.
™
Programming and Control
above is set by
X?
5-35