Extron electronics System 5 IP Series User Manual page 94

SIS ™ Programming and Control, cont'd
Command/response table for special function SIS commands, continued
Command
Input switching lockouts
Lock out input switching during power on/off
Input switching lockout duration
Switching lockout applies only to input buttons.
PINs (personal identification numbers)
Use personal identification numbers (PINs) to allow different types of access to switcher controls. These PINs can be
enabled only during times when the projector or display is powered off.
24
Enable PINs
Set a PIN 24
24
Read/display the PIN
5-38 System 5 IP • SIS
ASCII Command Response
(host to MLC)
24
* 53 #
X?
24 * 54 #
X?
* 60 #
X?
* * 61 #
X? Y?
* 61 #
X?
™
Programming and Control
X?
(MLC to host) and additional descriptions
PrwLock* This command prevents input
X?
switching during display warm
up and cool down sequences.
For
0 = off/disabled (default)
1 = on/enabled.
IODelay* Use this command to prevent
X?
input switching for a specific
period after an input has been
switched.
X?
(0 - 65535 ms in 20 ms steps).
PINEnable* For
X?
0 = all levels (administrator and
user PINs) are enabled
1 = the administrator PIN is
enabled
2 = PIN-based access is disabled
for all levels (default).
PINNum * This command allows you to set
X? Y?
a PIN for each level of access.
For
0 = administrator level
1 = user level.
Y?
the numbers 1, 2, 3, 4, and 5.
Default
follows:
• administrator = 1524
• user = 0.
For
Y?
0 = administrator level
1 = user level.
Y?
values
,
X?
= the lockout period
,
X?
,
X?
= any 4-digit combination of
values are as
Y?
,
X?
= the 4-digit PIN.