Rear/Bottom/Side Panel Features And Cabling - Extron electronics CVEQ1 User Manual

im Vertrieb von
Installation, Setup, Operation, cont'd

Rear/Bottom/Side Panel Features and Cabling

CVEQ1
Rear Panel
AUDIO OUTPUT VIDEO OUTPUT POWER
L R
1 2 3
CVEQ1 WM
Side Panel
3
1
2
Audio Captive Screw Con_
CVEQ1_090605.eps
CVEQ1
CVEQ1 Unbalanced Audio Output
Tip
See Caution.
Sleeve(s)
Tip
See Caution.
CAUTION Connect the sleeve to ground
(Gnd). Connecting the sleeve to
a negative (–) terminal will
damage the audio output circuits.
CVEQ1 Balanced Audio Output
Tip
Ring
Sleeve(s)
Tip
Ring
5 mm
www.camboard.de
CVEQ1 Series • Installation, Setup, Operation
2-6
CAMBOARD Electronics
CVEQ1 AAP
Bottom Panel
3 1
2
1
Audio output connector
— Cable an audio device to
the line driver via this female
5-pole captive screw connector.
Wire the male connector as
shown below.
Audio Captive Screw Con_
CVEQ1 WM-AAP_090605.eps
CVEQ1 WM, CVEQ1 AAP
CVEQ1 WM, CVEQ1 AAP
Unbalanced Audio Output
Tip
See Caution.
Sleeve(s)
Tip
See Caution.
CAUTION Connect the sleeve to ground
(Gnd). Connecting the sleeve to
a negative (–) terminal will
damage the audio output circuits.
CVEQ1 WM, CVEQ1 AAP
Balanced Audio Output
Tip
Ring
Sleeve(s)
Tip
Ring
5 mm
Tel. 07131 911201
Fax 07131 911203
2
Video output connector — Using a coaxial cable, connect
a display device to this female BNC connector. For the
CVEQ1 WM and CVEQ1 AAP, the BNC is at the end of a short
pigtail on the circuit board.
3
Power supply connection — On the CVEQ1 the power input
connector is a 2-pole jack that can be used to connect a 9 VDC
Power Connector wiring_compact.eps
to 24 VDC, 1 A (maximum), external power supply. If you
use an unterminated power supply (Extron parts #70-055-01
or #28-071-02, or #60-357-01 or
Power Input
#60-432-01), connect the tip of the
jack to the positive (hot) wire, and
Tip (+) Sleeve Tip (+)
the sleeve to the negative/ground
Sleeve
wire, as shown in the illustration at
left.
Use a 9 VDC to 24 VDC power supply.
A 12 VDC supply is recommended.
The CVEQ1 WM and CVEQ1 AAP have a female captive screw
connector instead of a jack for
connecting an external power
source. Wire the power connection
as shown at right.
ce-info@camboard.de
CVEQ1 Series • Installation, Setup, Operation
CVEQ1 AAP/CVEQ WM Rear Panel
Power Connector
Positive
N/C
Negative
5 mm
2-7