Lcd Menus And Basic Switcher Setup - Extron electronics System 5 IP Series User Manual

Front Panel Features and Basic Operation, cont'd

LCD Menus and Basic Switcher Setup

You can configure some basic settings (video type, RGB delay, audio input gain,
bass and treble levels, audio balance, mode, and output level settings) and control
the output volume by using the LCD, the Menu and Next buttons, and the
Volume/Adjust knob. The rest of the configuration must be performed using the
Windows-based configuration software via RS-232 or Ethernet control, or via the
switcher's embedded Web pages.
The Menu button (
menus: Video Config, Audio Adjust, Audio Settings, and Exit Menu.
Use the Next button (
The Volume knob (
volume (as shown below) in regular user mode (when menus aren't active), and to
let you change settings when a submenu is active.
Volume
Volume
Adjusting the volume (note the volume indicator bar)
The following illustration is an example of what you see on the LCD during the
switcher power-on sequence and as you move from main menu to main menu.
Power
on
System 5 IP main menu overview
The illustration on the next page shows the main menus, submenus, and
adjustment options.
3-8 System 5 IP Switchers • Front Panel Features and Basic Operation
) provides access to and lets you move between the main
MENU
) to select and move between submenus.
NEXT
) has two functions: to allow you to change the output
VOLUME VOLUME
Volume
ADJUST ADJUST
VOLUME VOLUME
Volume
ADJUST ADJUST
Firmware
Ver2.00
12 sec. 5 sec.
Extron Video 1
System 5 Audio 3
MENU
Timeout (12 sec.)
NEXT
Video output may turn off briefly (for the duration of the RGB delay setting)
while you set the video configuration for inputs 1 and 2 or when you press the
Menu and Next buttons and enter the Video Config menu, whether or not you
make any changes to the configuration.
VOLUME
Volume Volume
ADJUST
VOLUME
Volume Volume
ADJUST
Volume
MENU
VIDEO
CONFIG
MENU
AUDIO
ADJUST
MENU
AUDIO
SETTINGS
MENU
EXIT
MENU