Using The Dolby Digital And Dolby Pro Logic Modes - JVC RX-1024VBK Instructions Manual

Using the Dolby Digital and Dolby Pro Logic Modes

Once you have adjusted the Dolby Digital and Dolby Pro Logic modes, this receiver
memorizes adjustment for each mode.
To activate the Dolby Digital and Dolby Pro Logic modes, follow the procedure below.
From the remote control:
1. Select and play the source encoded with Dolby Digital (bearing the mark
) or with Dolby Surround (bearing the mark
D I G I T A L
• When you play back the source encoded with Dolby Digital and select the digital
input for that source, the Ÿ DIGITAL indicator lights up on the display.
2. Press SURROUND MODE repeatedly until "PRO LOGIC"
or "DOLBY DIGITAL" appears on the display.
Dolby Digital or Dolby Pro Logic is automatically selected
according to the source being played back.
When Dolby Pro Logic is selected, the lamp on the DOLBY SURROUND button
(on the front panel) lights red.
When Dolby Digital is selected, the lamp on the DOLBY SURROUND button (on
the front panel) lights green.
Each time you press the button, the DSP modes change as follows:
When the digital input is selected to play the source encoded with Dolby
Digital:
DOLBY DIGITAL
OFF
For other sources:
PRO LOGIC
OFF
3D THEATER 3D DRAMA
If you need to make any adjustment, go to the following steps.
3. Press SOUND.
10 keys are activated for sound adjustments.
DIG-THEATER
3D DIGITAL
HEADPHONE
THEATER LIVE CLUB
3D ACTION
).
DOLBY SURROUND
SURROUND
MODE
DANCE CLUB
HALL
PAVILION
HEADPHONE
SOUND
Continued to the next page.
Notes:
• To enjoy the software encoded
with Dolby Digital, you must
connect the source
component using the digital
terminal on the rear of this
receiver.
• When the signals come into
this receiver through the
analog connection from the
source component, "PRO
LOGIC" is automatically
selected.
• The Surround mode is not
used with the other DSP
modes such as the DAP mode
and 3D-PHONIC mode. When
the Surround mode is turned
on, the other DSP mode, if
used, will be turned off.
Notes on the indications:
• The PRO LOGIC indicator
lights up when the Dolby Pro
Logic decoder built in this
receiver is activated.
• The Dolby Pro Logic decoder
is used not only for the analog
sources but also for the
sources encoded with Dolby
Digital in the following cases:
– When only front channel
signals are encoded.
– When front channel and
monaural rear channel
signals are encoded.
While the Dolby Pro Logic is
activated for this type of Dolby
Digital source, the Ÿ DIGITAL
indicator goes off.
34