Attenuating The Input Signal; Adjusting The Subwoofer Output Level; Recording A Source - JVC RX-1024VBK Instructions Manual

Attenuating the Input Signal

When the input level of the playing source through the analog terminals is too high, the
sounds will be distorted. If this happens, you need to attenuate the input signal level to
prevent the sound distortion.
On the front panel only :
Press and hold SOUND SELECT/INPUT ATT until "INPUT
ATT ON" appears on the display.
The ATT indicator also lights up on the display.
Each time you press and hold the button, the input attenuator mode
turns on ("INPUT ATT ON") and off ("INPUT NORMAL").
You can set input attenuator mode separately for each source.

Adjusting the Subwoofer Output Level

You can adjust the subwoofer output level if you have selected "YES" for the
"SUBWOOFER" (see page 18).
Once it has been adjusted, the receiver memorizes the adjustment.
On the front panel:
1. Press BALANCE/SURROUND ADJUST repeatedly until
"SUBWFR LEVEL" appears on the display.
The display changes to show the current setting.
2. Turn MULTI JOG to adjust the subwoofer output level (–
10 dB to +10 dB), while the indication of the previous step is
still on the display.
From the remote control:
1. Press SOUND.
10 keys are activated for sound adjustments.
2. Press SUBWOOFER +/– to adjust the subwoofer output
level (–10 dB to +10 dB).

Recording a Source

You can record any source playing through the receiver to the cassette deck or the MD
recorder connected to the TAPE/MD jacks and the VCRs connected to the VCR1 and
VCR2 jacks at the same time.
While recording, you can listen to the selected sound source at whatever sound level
you like, without affecting the sound levels of the recording.
Notes:
• This function is available only
for the sources connected
using the analog terminals.
• This function takes effect only
when the DSP mode is in use.
SOUND SELECT
INPUT ATT.
BALANCE/SURROUND
ADJUST
MULTI JOG
SOUND
– +
SUBWOOFER
0 +10
100+
FM MODE/
MUTE
Note:
The output volume level and
SEA modes cannot affect the
recording.
IMPORTANT:
When recording the digital
source, turn off the DSP mode.
16