JVC RX-1024VBK Instructions Manual page 42

Using the DSP Modes
On the front panel:
You can also use the buttons on the front panel to adjust the Theater Surround mode.
However, no test tone is available when using the buttons on the front panel. So, make
adjustments while listening to the sound of the source played back.
1. Select and play the source encoded with Dolby Digital (bearing the mark
) or with Dolby Surround (bearing the mark
D I G I T A L
• When you play back the source encoded with Dolby Digital and select the digital
input for that source, the Ÿ DIGITAL indicator lights up on the display.
2. Press DSP MODE.
The current DSP mode appears on the display.
3. Turn MULTI JOG until "THEATER" or "DIG-
THEATER" appears on the display, while the indication of
the previous step is still on the display.
The DSP and THEATER indicators also light up on the display.
As you turn it, the DSP modes change as follows:
When the digital input is selected to play the source encoded with Dolby
Digital:
DIG-THEATER
For other sources:
THEATER
DSP OFF
3D THEATER
If you need to make any adjustment, go to the following steps.
4. Adjust the speaker output levels as follows.
1) Press BALANCE/SURROUND ADJUST repeatedly
until one of the indications appears on the display.
"CENTER LEVEL": To adjust the center speaker level.
"REAR L LEVEL":
"REAR R LEVEL": To adjust the right speaker level.
2) Turn MULTI JOG to adjust the selected speaker output
level (from –10 dB to +10 dB), while the indication of the
previous step is still on the display.
3) Repeat 1) and 2) to adjust the other speaker output
levels.
39
HEADPHONE
DSP OFF
3D DIGITAL
LIVE CLUB DANCE CLUB
3D DRAMA 3D ACTION
To adjust the left speaker level.
).
DOLBY SURROUND
DSP MODE
MULTI JOG
HALL
PAVILION
HEADPHONE
BALANCE/SURROUND
ADJUST
MULTI JOG
Notes:
• To enjoy the software encoded
with Dolby Digital, you must
connect the source
component using the digital
terminal on the rear of this
receiver.
• The Surround mode is not
used with the other DSP
modes such as the DAP mode
and 3D-PHONIC mode. When
the Surround mode is turned
on, the other DSP mode, if
used, will be turned off.
Notes on the indications:
• The PRO LOGIC indicator
lights up when the Dolby Pro
Logic decoder built in this
receiver is activated.
• The Dolby Pro Logic decoder
is used not only for the analog
sources but also for the
sources encoded with Dolby
Digital in the following cases:
– When only front channel
signals are encoded.
– When front channel and
monaural rear channel
signals are encoded.
While the Dolby Pro Logic is
activated for this type of Dolby
Digital source, the Ÿ DIGITAL
indicator goes off.
Notes:
• You cannot adjust the center
speaker level when "CENTER
SPK" is set to "NONE" (see
page 19).
• You cannot adjust the rear
speaker levels when "REAR
SPK" is set to "NONE" (see
page 19).