Creating Your Own Sea Mode - JVC RX-1024VBK Instructions Manual

Using the SEA Modes

Creating Your Own SEA Mode

You can adjust and store your own SEA adjustment into memory (SEA USERMODE).
On the front panel only :
If you do not want to store your adjustment, but rather want to adjust the SEA
temporarily, skip step 4 below.
1. Press SEA ADJUST repeatedly until the frequency range
(100Hz, 1kHz or 10kHz) you want appears on the display.
S E A FR
100 1k 10k
S E A FR
100 1k 10k
2. Turn MULTI JOG to adjust the SEA level of the selected
frequency range, while the indication of the previous step is
still on the display.
• Turning it clockwise increases the level.
• Turning it counterclockwise decreases the level.
This FR means this adjustment can be
applied to the front speakers only
S E A FR
100 1k
3. Repeat step 1 and 2 to adjust other frequency ranges if
necessary.
4. Press TUNER/SEA MEMORY, while the indication of the
previous step is still on the display.
Your adjustment is stored into the SEA USERMODE.
To recall your own SEA adjustment
See page 26.
To erase a stored adjustment
Storing a new adjustment into SEA USERMODE erases the previously stored one.
27
10k
SEA ADJUST
VOLUME
VOLUME
MULTI JOG
TUNER/SEA MEMORY