Replacing The Label Sensor - CAB XC Series Service Manual

16 4 Replacing Assembly Units
4.5

Replacing the Label Sensor

Notice!
i
Soiling of the label sensor can also cause malfunctions.
 Before replacing the label sensor, check whether it is soiled and clean it if necessary  3.2 on page 7.
Danger!
Risk of death via electric shock!
 Before opening the rear cover, disconnect the device from the mains supply and wait at lease one
minute until the power supply unit has discharged.
Fig. 14 Replacing the label sensor
Removing the label sensor
1. Remove media from the printer.
2. Remove the rear cover  2.2 on page 6.
3. Slide the label sensor assembly onto the tab (5) toward the rear cover until it stops.
4. Unplug the cable (1) from the plug on the rear end of the label sensor (2).
5. Unscrew the screws (3) and remove the side plate (4).
6. Pull out the label sensor (2) via the tab (5) toward the cover side. At XC6 that way the distance plate (6) is pushed
out of label sensor guide.
Installing the label sensor
1. Insert the label sensor (2) into the guide from the front cover side and slide it toward the rear cover until it stops.
At XC6 push the distance plate (6) into the guide of the label sensor.
2. Remount the side plate (4) with the screws (3) by tightening the screws in order, i.e. a, b then c.
3. Connect the cable (1) to the label sensor (2).
4. Pull the label sensor (2) via the tab (5) as far as possible toward the front cover side.
This prevents the cable (1) from being pinched when installing the rear cover.
5. Install the rear cover.
6. Adjust the label sensor  Configuration Manual.
1 2
3c 3b 3a 4 2 5
16
6