Outdoor Unit - Daikin Super Multi Plus D-Series Service Manual

Instruction

Outdoor Unit

18
Indoor Unit
1. Air filter
2. Titanium Apatite Photocatalytic
Air-Purifying Filter:
• These filters are attached to the inside of the air
filters.
3. Air inlet
4. Front panel
5. Panel tab
6. Room temperature sensor:
• It senses the air temperature around the unit.
7. INTELLIGENT EYE sensor:
• It detects the movements of people and
automatically switches between normal
operation and energy saving operation.
8. Display
9. Air outlet
10. Flaps (horizontal blades)
11. louvers (vertical blades):
• The louvers are inside of the air outlet.
Outdoor Unit
17. Air inlet: (Back and side)
18. Air outlet
19. Refrigerant piping and inter-unit cable
20. Drain hose
Appearance of the outdoor unit may differ from some models.
148
17
12. Indoor Unit ON/OFF switch:
13. Operation lamp (green)
14. TIMER lamp (yellow)
15. INTELLIGENT EYE lamp (green)
16. Signal receiver:
21. Earth terminal:
22. Outside air temperature sensor:
22
• Push this switch once to start operation. Push
once again to stop it.
• The operation mode refers to the following
table.
Temperature
Mode
setting
F(C)TKS COOL 22°C
F(C)TKS AUTO
25°C
• This switch is useful when the remote control is
missing.
• It receives signals from the remote control.
• When the unit receives a signal, you will hear a
short beep.
• Operation start...............beep-beep
• Settings changed...........beep
• Operation stop...............beeeeep
• It is inside of this cover.
• It senses the ambient temperature around
the unit.
SiEBE18-526
19
20
21
Air flow
rate
AUTO
AUTO
System Configuration