Vsl: Setup Tab - PRESONUS StudioLive 24.4.2 Owner's Manual

7 Software: Universal Control, SL Remote, Capture, and Studio One Artist
7.2 Virtual StudioLive
Enabling a GEQ
Flattening a GEQ Curve

VSL: Setup Tab

7.2.6
PHYSICAL
Main Mix Left
Main Mix Right
Subgroup 1
Subgroup 2
Subgroup 3
Subgroup 4
Aux Send 3
Aux Send 4
84 84
By default, all Graphic EQs on your StudioLive 24.4.2 are disabled. To
enable them remotely, via VSL, simply click on the Enable button to the
left of the sliders.
To zero out all curve settings on any GEQ, click on the Flatten GEQ button,
which is directly below the Enable button. This will flatten all band gains
to 0 dB so that they neither boost nor attenuate any of the 31 bands.
As discussed in Section 6.4.2, the StudioLive allows you to route to
a computer the mixer's 24 input channels and any 8 of 23 buses and
other inputs. This is done via the Auxiliary Inputs Router on the Setup
tab. To route FireWire Sends 25 through 32, first decide which buses
and inputs you would like to record in addition to your input channels.
Once you've determined your input pairs, simply patch them to a
stereo pair of auxiliary inputs of your choice. Remember, all of these
buses and inputs are automatically set to send their signals post-
Fat Channel dynamics and post-EQ (where applicable). The inputs
and buses selected in the Auxiliary Input Router will be displayed
in your recording application with the name of their routing.
PreSonus StudioLive
For instance, the routed pairs in the
picture would translate as the following
chart in your host recording application:
SOFTWARE
Auxiliary In 25
Auxiliary In 26
Auxiliary In 27
Auxiliary In 28
Auxiliary In 29
Auxiliary In 30
Auxiliary In 31
Auxiliary In 32
24.4.2
™