Creating And Recalling A Scene - PRESONUS StudioLive 24.4.2 Owner's Manual

Owner's Manual
The StudioLive's recallable parameters are grouped as follows:
• Mute: All channel and bus mutes (Channels 1-24, Subgroups 1-4, FXA, FXB)
• FX: All parameters for the internal effects assigned to FXA and FXB
• Assigns: All output and bus routing (Mains, Subgroups, Stereo Linking,
FireWire Returns to Inputs, Solo and Monitor bus assignments,
and Master Control Assignments - including Talkback)
• EQ and Dyn: All Fat Channel dynamics processing and filter
parameters (Phase, High Pass, Noise Gate, Compressor, EQ, and
Limiter) as well as the pan position for every channel and bus
• Aux Mix: All aux mixes (analog Aux Mixes 1-10, FXA and FXB, and Pre1/Pre2 positions)
• Faders: All fader positions
• Pots: All digital knob positions (Aux 1-10 Outputs, FXA and FXB Levels, Cue, 2
Track In, Phones, Monitor, Talkback, and Aux Input A and Aux Input B knobs)
• GEQ: Graphic EQ settings
If you enable Fader positions as a part of your Scene recall, the StudioLive will
automatically put the meters in Fader Locate mode after you press the Recall
button. The Fader Locate button will illuminate, and the meter section of the Fat
Channel will display the recalled fader position. Move the faders up or down until
only the center LED is illuminated in each meter to recall the stored position. The
subgroup and main meters at the top right of the StudioLive will display the
recalled positions for their respective faders. As long as you remain in Fader Locate
mode, the faders on your StudioLive will not be active. The level of the audio
passing through them will be set according to the stored fader position, not the
current location of the physical fader. Once you have recalled each of the faders to
their Scene location, press the Locate button again. This will take you out of Fader
Locate mode and reactivate your faders so that they control the level of their
channels and buses.
If you enable knob positions (Recalling Group "Pots") as a part of your Scene
recall, all of the digital knobs (Aux 1-10 Outputs, FXA and FXB Levels, Cue,
2 Track In, Phones, Monitor, Talkback, Aux Input A and Aux Input B knobs)
will remain at their stored position until they are moved manually. Once
a knob is turned, its value will jump to the value of its current physical
position. Therefore, if you intend to save a Scene and recall the "Pots" group
later, it is highly recommended that you use the recall sheet provided in
the back of this manual to note the stored position of these controls.
It is important to note that the recalling groups have no effect on what
parameters are stored with a scene. All storable parameters are saved
with a scene regardless of what recalling groups are enabled.
Scenes, Presets, System Menu, and MIDI Control

Creating and Recalling a Scene

5
5.1
53 53