Table of Contents
Advertisement
d Color temperature
Displays a color temperature calculated from the
gain of R and B, in the range 0.0 K to 99.9 K (in
steps of 0.1 K). The +/– signs may be displayed
depending on the OFFSET WHT setting (see
page 138).
No display: OFFSET WHT is OFF
+: The value of OFFSET WHT is greater than
3200K.
–: The value of OFFSET WHT is less than
3200K.
e Wireless microphone reception level
When a UHF portable tuner is installed in the
camcorder, "W" appears together with four-
segment reception level indicators for each of the
channels (1 or 2 channels) of the tuner. The
indications are as follows.
Normal use: The number of white segments
indicates the strength of the signal level.
Muted: The number of gray segments indicates
the strength of the signal level.
Reception level over peak: "P" is displayed
instead of the indicators.
Tuner battery is low: The channel number and
indicator of the corresponding channel
1)
flash.
1) DWR-S01D only
f Power source voltage/battery
remaining capacity
When the unit is powered from a battery pack,
indicates the remaining capacity of the power
source voltage. When the unit is powered from a
battery connected to the DC IN connector or AC
adaptor attached to the battery attachment shoe,
indicates the power source voltage.
g External battery
Appears if the power is supplied from an AC
adaptor connected to the DC IN connector.
h External device control
Flashes when recording operation by the external
device connected to the HDSDI OUT connector
is being controlled.
However, this indicator only appears when
HDSDI REMOTE I/F on the CAM CONFIG 2
page of the MAINTENANCE menu is set to
CHARA and HD SDI OUT on the OUTPUT 1
page of the OPERATION menu is set to HDSDI.
1)
i Electric CC (color temperature) filter
Displays the color temperature when the electric
CC filter is ON.
j Filter
Indicates the currently selected filter type (see
page 12).
k White balance memory
Indicates the currently selected white balance
automatic adjustment memory.
A: Displayed when the WHITE BAL switch is set
to A.
B: Displayed when the WHITE BAL switch is set
to B.
P: Displayed when the WHITE BAL switch is set
to PRST or when the preset button on an RM-
B150 has been pressed.
T: Displayed when ATW is being used.
l Gain value
Indicates the gain value (in dB) of the video
amplifier, as set by the GAIN selector.
m Shutter speed
Indicates the shutter speed or the shutter mode.
However, if the SHUTTER selector (see page 12)
is set to OFF, nothing is displayed.
For details of the displayed shutter speed, see
"Setting the Electronic Shutter" on page 50.
n Operation/alarm message display area
For details, see "Operation/alarm messages" on
page 162.
o Audio level
Indicates the level of audio channel 1 and channel
2. The peak indication of the VTR level meter is
related as follows to the audio level.
1
2
3
-40
-30
1Audio channel 1 level indicator
2Audio channel 2 level indicator
3VTR level meter indicator
p Remaining tape recording time
Indicates the remaining recording time (in
minutes) of the tape.
Locations and Functions of Parts and Controls
-20 -17 -14(dB)
27
Advertisement
Table of Contents
