Table of Contents
Advertisement
2
Preparations
Chapter
Preparing a Power
Supply
For safety, use only the Sony battery packs listed
below.
• BP-GL95/GL65/L60S/L80S Lithium-ion
Battery Pack
• AC power using the AC-DN2B/DN10 AC
adaptor
Using a battery pack
When a BP-GL95/GL65/L60S/L80S Battery
Pack is used, the camcorder will operate
continuously for the time shown below.
Model name
Operating time
BP-GL95
Approx. 120 minutes
BP-GL65
Approx. 70 minutes
BP-L60S
Approx. 70 minutes
BP-L80S
Approx. 95 minutes
Note
The battery pack operating time depends on the
frequency of use of the battery pack, and the ambient
temperature when used.
Before use, charge the battery pack with a charger
suitable for each battery.
For details on the battery charging procedure, refer
to the battery charger operation manual.
Note on using the battery pack
A warm battery pack may not be able to be fully
recharged.
To attach the battery pack
1
Press the battery pack against the back
of the camcorder, aligning the line on
the side of the battery pack with the
matching line on the camcorder.
1BP-GL95/GL65/L60S/L80S
2Align these lines.
2
Slide the battery pack down until its
"LOCK" arrow points at the matching
line on the camcorder.
1"LOCK" arrow
2Matching line on the camcorder
Note
If the battery pack is not attached correctly, the terminal
may be damaged.
To detach the battery pack
Holding the release button in, pull the battery
pack up.
Preparing a Power Supply
1
2
1
2
29
Advertisement
Table of Contents
