Table of Contents
Advertisement
VOLT: The voltage (VOLT) is displayed
continuously.
VF DISP 3 page
Item
LOW LIGHT
LOW LIGHT LEVEL Sets the LOW LIGHT
VF BATT WARNING Specifies the
3
Turn the MENU knob to select the
desired setting (ON, OFF, or value), and
press the MENU knob.
4
Repeat steps 2 and 3 until you have set
all of the desired items.
Change confirmation/adjustment
progress messages
You can limit or suppress the messages that give
details of setting changes and adjustment
progress and results by setting a display mode.
The conditions under which messages are
displayed and their correspondence with the
display mode are as follows:
Y: Message is displayed.
N: Message is not displayed.
Message display
Message
condition
When the filter
ND: n (where n =
selection has
1, 2, 3, 4)
been changed
or CC: m (m=A,
B, C, D)
Description
Turns on and off the
on-screen warning
that the average level
of the video has
dropped beneath a set
level.
threshold value.
remaining battery
capacity level that
starts the flashing
warning in the
viewfinder.
Display
mode
setting
1
2
3
N
N
Y
Setting the Status Display on the Viewfinder Screen and the LCD Monitor
Message display
Message
condition
When the gain
GAIN: n (where
setting has been
n = –6dB, –3dB,
changed
0dB, 3dB, 6dB,
9dB,12dB, 18dB,
24dB, 30dB,
36dB, 42dB)
When the setting
WHITE: n
of the WHITE
(where n = A
BAL switch has
CH, B CH,
been changed
PRESET) or
ATW: RUN
When the
DCC: ON (or
OUTPUT/DCC
OFF)
switch has been
set to DCC ON
or OFF
When the shutter
:SHUTTER:
speed and mode
1/100
setting has been
(or 1/125, 1/250,
a)
1/500, 1/1000,
changed
1/2000, ECS,
SLS)
When the black
E.g. AWB : OK
or white balance
has been adjusted
a) This is also displayed for about 3 seconds when the
SHUTTER selector is set to ON.
Changing the display mode
1
Display the VF DISP 1 page of the
OPERATION menu on the screen, and
press the MENU knob.
For details on menu operations, see "Basic
menu operations" on page 117.
2
Select VF DISP MODE, and press the
MENU knob.
3
Select the desired display mode, and
press the MENU knob.
Selecting the conditions that light
the '!' (warning) indicator
Select the items that light the viewfinder indicator
on the '!' LED page of the OPERATION menu,
Display
mode
setting
1
2
3
N
N
Y
N
N
Y
N
Y
Y
N
Y
Y
N
Y
Y
129
Advertisement
Table of Contents
