Interlock Switches; Traction Lever; Reel Control - Jacobsen Greens King IV Plus Safety, Operation & Maintenance Manual

9.11 INTERLOCK SWITCHES ____________________________________________________

1. Refer to the Interlock System check in your Safety &
Operation manual. If the system fails any test listed,
adjustment or replacement of the switches or levers
is required.
2. Remove the front cowling and check the control
linkages to be sure they are properly adjusted
(Sections 9.10, 9.12 and 9.13).

9.12 TRACTION LEVER _________________________________________________________

1. Remove front cowling and adjust lever to align with
the four positions on the instrument panel.
2. Adjust ball joints (M) on rod (N) and/or adjust
position and number of washers (P) for proper
alignment. The lever must engage Neutral start
switch in NEUTRAL position only.

9.13 REEL CONTROL___________________________________________________________

Adjust the reel control lever linkage so the reels
disengage when they reach the raised position.
1. Remove front cowling and raise mowers. Shift all
reel control levers to OFF and stop engine.
2. Adjust link (R) so there is 1/32 to 1/16 in. (0.8 to
1.6 mm) clearance between the bottom of the
shoulder bolt (S) and the bottom of the slot in link
(R).
3. Remove all hardware holding link (R) in place then
loosen nut (T) and adjust the link.
3. Tighten nut (T) against the link. Reassemble all
components and tighten hardware.
3. Check switches to make sure they are working
properly.
!
CAUTION
Never operate equipment with damaged switches.
Replace faulty switches immediately.
1/32 to 1/16 in.
(0.8 to 1.6 mm)
ADJUSTMENTS
P
M
N
M
Figure 9K
T
R
S
Figure 9L
9
GKV-15
41