Parking Brake; Interlock Switches; Traction Lever; Choke Control - Jacobsen Greens King IV Plus Parts & Maintenance Manual

3.8

PARKING BRAKE__________________________________________________________

Disengage brake lever and measure the distance
between nut (G) and bottom of pivot. Adjust nut so the
distance is 3/16" (5 mm).
3.9

INTERLOCK SWITCHES ____________________________________________________

1. Refer to the Interlock System check in your Safety &
Operation manual. If the system fails any test listed,
adjustment or replacement of the switches or levers
is required
2. Remove the front cowling and check the control
linkages to be sure they are properly adjusted
(Sections 3.8, 3.10 and 3.12).

3.10 TRACTION LEVER _________________________________________________________

1. Remove front cowling and adjust lever to align with
the four positions on the instrument panel.
2. Adjust ball joints (M) on rod (N) and/or adjust
position and number of washers (P) for proper
alignment. The lever must engage neutral start
switch in "NEUTRAL" position only.

3.11 CHOKE CONTROL _________________________________________________________

Gas Engines Only
1. Push choke control knob to the "Off" Position.
2. Set Choke lever at carburetor to "Off" (butterfly
open) position.
ADJUSTMENTS
3/16"
(5 mm)
G
3. Check switches to make sure they are working
properly.
!
Never operate equipment with damaged switches.
Replace faulty switches immediately.
3. Adjust control wire (at the carburetor) then clamp
wire housing in place while keeping choke butterfly
open and the control knob in the "Off" position.
Figure 3H
CAUTION
P
M
N
M
3
GKV-13
GKV-15
Figure 3I
GB-11