Konica Minolta DF-606 Service Manual page 92

3. OTHER PARTS
[2]
[1]
[3]
[4]
[3]
[1]
[2]
[3]
[7]
46
1
[2]
15sjf2c057nb
[5]
[5]
[1]
[4]
[6]
15sjf2c051na
Field Service Ver2.0 Aug.2005
6. Pull out the stacker unit [1] and remove the 2
screws [2] of the rail stopper. And then pull further
out the stacker unit.
Note
• In order to prevent the FS from falling down,
be sure to place a support [3] beneath the
stacker unit that has been pulled out.
7. Remove 2 screws [1], and then lift up the stacker
unit [2] and remove it from the guide rails [3].
Note
• When removing the stacker unit, be careful of
your posture not to suffer a crick in the back.
• While using care not to damage the cartridge
guide rail [6] of the stapler, be sure to place
the stacker unit that has been removed on the
flat floor with its side on which the stapler unit
[7] is installed down.
8. Reinstall the above parts following the removal
steps in reverse.
Note
• When installing the stacker unit [2] to the
guide rail [3], be sure to check to see if the
hooks [4] at 4 places are set securely into the
installation holes [5].