Checking Interfaces - Omron NT31 Setup Manual

System Maintenance

6-11-8 Checking Interfaces

Checking
Communications with the
Support Tool
214
Note When The voltage is lowered is displayed, replace the built-in battery immedi-
ately. For details on the replacement method, refer to 7-3-1 Replacing the Bat-
tery (page 243).
The NT31/NT31C allows the following communications functions to be
checked.
• Communications with the Support Tool page 214
• Communications at serial ports
• Communications with printers
Check communications with the Support Tool by following the menu operation
from the System Menu shown below.
page 215
page 218
Ver 4.12
Select Maintenance Mode.
Select I/O Check.
Select I/F Check.
Section 6-11