Setting The Printer Controller - Omron NT31 Setup Manual

System Settings
Reference:
6-9-5

Setting the Printer Controller

The default (factory) setting is OFF.
• There are other instructions and settings relating to the buzzer, but this
memory switch setting has the highest priority.
• For details on the buzzer, refer to 2-15-5 Buzzer Function in the Refer-
ence Manual.
Set the buzzer sound by following the menu operation from the System Menu
shown below.
Ver 4.12
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [ ] (previous screen) touch switch, then make the setting.
• To confirm the settings and quit the memory switch setting screen, press
the Quit touch switch. The settings made last will be set and the NT31/
NT31C will return to the MAINTENANCE MODE MENU screen.
• To quit the memory switch setting screen without confirming the settings,
press the Abort touch switch. The NT31/NT31C will return to the MAIN-
TENANCE MODE MENU screen with the previous settings still in effect.
The NT31/NT31C has a function for printing out data at a printer connected to
it in response to an instruction from the host or operation at the NT31/NT31C.
Three types of printer can be connected to the NT31/NT31C: select the type
used with this memory switch setting.
• ESC/P:
Select Maintenance Mode.
Select Memory Switch.
Press Buzzer Sound to display ON, OFF,
or ERROR ON.
The setting option changes each time
the touch switch is pressed.
Section 6-9
173