Abnormal State (Command : Z); Ism Mode (Command : J P); Auto Configure (Command : J U) - HP LD4200tm User Manual

3 : User

16. Abnormal state (Command : z)

Abnormal State : Used to Read the power off status when Stand-by mode.
Transmission
[k][z][ ][Set ID][ ][Data][Cr]
Data FF : Read
0 : Normal (Power on and signal exist)
1 : No signal (Power on)
2 : Turn the display off by remote control
3 : Turn the display off by sleep time function
4 : Turn the display off by RS-232C function
8 : Turn the display off by off time function
9 : Turn the display off by auto off function
Acknowledgement
[z][ ][Set ID][ ][OK][Data][x]

17. ISM mode (Command : j p)

Used to select the afterimage preventing function.
Transmission
[j][p][ ][Set ID][ ][Data][Cr]
Data 1H : Inversion
2H : Orbiter
4H : White Wash
8H : Normal
10H : Dot Wash
Acknowledgement
[p][ ][Set ID][ ][OK][Data][x]

18. Auto Configure (Command : j u)

To adjust picture position and minimize image shaking automatically. It works only in RGB(PC) mode.
54 Appendix C Controlling the Multiple Product ENWW