Viewing The Last Call Log; Cancelling An Activation - Menvier Security SD1 Operating Instructions Manual

SD1 Operating Instructions

10. Viewing The Last Call Log

When a call is successfully acknowledged the SD1 stores the event in a "Last Call Log".
The log may then be viewed as follows:
Ensure that the SD1 is initialised and the
display is showing "READY".
The display will show the Last Call Log e.g.,
"SENT A to [-2-]" (Alarm on trigger input A
acknowledged by recipient 2). If the display
shows [---] then none of the calls was
acknowledged.
Press the ] key to return to "READY"

11. Cancelling an Activation.

Occasionally you may trigger your alarm by accident and cause the SD1 to send an
unwanted call. When this happens the unit cannot be stopped by pressing the ] key or any
of the other keys. Control of the SD1 is disabled until the call has been successfully
acknowledged or until the unit has cleared down after the final attempt.
However there are two actions you may try to ensure that the alarm is intercepted:
1. If a telephone is connected on the same line as the SD1 you may lift the handset
and talk over the top of the SD1 message. Advise the recipient of the call not to
respond to the alarm.
2. If a telephone is connected on the same line as the SD1 you may use it to
acknowledge the SD1 yourself (providing it is a tone type telephone).
Page 8
READY
Press the [ key
ENTER 1-3 OR 0-C
Press the [ key
SENT A TO [-2-]
Press the ] key