Quick Reference Guide - Menvier Security SD1 Operating Instructions Manual

If the unit is not operated for 1 minute, it will revert to
its normal standby mode and the display will show
Programming
Telephone Nos
Press [
ENTER 1-3 0R 0-C
Select No. 1, 2 or 3
(e.g., Press 1 )
PHONE NO. 1
Enter telephone No.
(e.g., 0811234567)
Press A to Clear
018112345678
Press [ to accept

QUICK REFERENCE GUIDE

Recording Messages
Press [
ENTER 1-3 OR 0-C
Select phrase:
0
= Com mon
phrase.
A = Phrase A.
B = Phrase B.
C = Phrase C.
RECORD PHRASE 0
P res s [ to start
RECORDING - 8
Speak clearly into the
unit. If message is less
than eight seconds in
length then press ] to
end recording
NOTE: When the unit is first switched on the display
PLEASE RE-RECORD
shows "PLEASE RE-RECORD" and the unit beeps every
When the SD1 is not being used the display shows
-ON-
"-ON-". To initialise it press and hold the [ key for 6
READY
Replaying Messages
Select Message:
A = Phrase 0 + Phrase
A.
B = Phrase 0 + Phrase
B.
PLAYING PHRASE 0
PLAYING PHRASE A
Playing message A.
Sending A Test Call
Press A then 1
SENDING A TO NO.1
Message A is being sent
to telephone No 1.
For other message
combinations press B
then 2, C then 1 etc. as
required
Test Activations
Press A then [
SENDING A TO NO.1
Message A is being sent
to telephone No 1.
SENDING A TO NO.2
Message A is being sent
to telephone No 2.
SENDING A TO NO.3
Message A is being sent
to telephone No 3.