Menvier Security SD1 Operating Instructions Manual page 7

7. Sending A Test Call
It is possible to test that each message plays to each of the telephone numbers. e.g., you
may want to test that "Message A" plays to telephone number 1 or "Message B" to telephone
number 3 etc.
Before sending a test call it is very important that the person that is being called is familiar
with the Call Acknowledgement Procedure. This will ensure that the SD1 is successfully
cleared down.
If the SD1 is not cleared down when it is triggered from the alarm panel it will either dial the
next telephone number (if one is programmed) or re-dial the first telephone number a further
two times.
The following example shows how to send "Message A" to telephone number 1:
Ensure that the SD1 is initialised and the
display is showing "READY".
Dialling telephone No. 1
The unit waits until the phone being called is
ringing. When the unit detects the ringing the
display will show "RINGING". If ringing is not
detected within 5 seconds the unit will start to
play the message.
The unit plays phrase 0 (Name & Address)
then the alarm phrase A (e.g., Fire Alarm
etc.). At the end of phrase A, the person
receiving the call should carry out the Call
Acknowledgement Procedure.
If the call is successfully acknowledged the
display will show "CALL SUCCESSFUL". If the
p erson rece iving the cal l f ails t o
acknowledge it on the first attempt the unit
will repeat the message four times, giving
them the opportunity to acknowledge the
call at the end of each message. However if
at the end of the last attempt they still fail to
acknowledge the call the display will show
"NO REPLY". The unit will clear down for 6
seconds, then re-dial the telephone number
a further two times.
Repeat for other test call combinations as
required.
SD1 Operating Instructions
READY
press the A key then the 1 key
SENDING A TO NOo1
RINGING
PLAYING PHRASE 0
PLAYING PHRASE A
CALL SUCCESSFUL
Test calls may be cancelled at any
time by pressing the ] key.
Page 5