Initialising The Sd1; Programming Telephone Numbers - Menvier Security SD1 Operating Instructions Manual

SD1 Operating Instructions

2. Initialising the SD1

When the SD1 is switched on the display will show "PLEASE RE-RECORD" and the unit will beep
every 30 seconds. This indicates that the memory is blank (i.e., all telephone numbers and
messages are blank).
Display shows "PLEASE RE-RECORD" when unit
is first switched on.
When initialised the display shows "READY",
the unit can now be programmed and
tested.
If the unit is not operated for 1 minute, it will
revert to its normal standby mode and the
display shows "-ON-".

3. Programming Telephone Numbers

The SD1 stores up to three telephone numbers with a maximum of 16 digits for each.
NOTE. Permission of the person(s) that are being called must be obtained before storing their
telephone number. The Emergency Services telephone numbers CANNOT be entered.
The following example shows how to set telephone number 1 as 081 1234567.
Ensure that the SD1 is initialised and the
display is showing "READY".
Pressing 1-3 selects telephone numbers 1, 2
or 3. 0-C selects phrases 0, A, B or C (see
section 4).
The display will alternate between "PHONE
No. 1" and the current telephone number
(B lan k i f th e numb er h as n ot been
programmed).
Pressing the A key will clear the display if a
mistake is made whilst entering the number.
Repeat for telephone number 2 and 3 as
required.
Page 2
Power switched on
PLEASE RE-RECORD
Press the [ key for 6 secs
READY
-ON-
READY
Press the [ key
ENTER 1-3 oOR 0-C
Select No. 1, 2 or 3
(e.g., Press 1 )
PHONE NO 1
Enter telephone No.
(e.g., 0811234567)
0811234567
Press the [ key to accept