Test Activation - Menvier Security SD1 Operating Instructions Manual

SD1 Operating Instructions

8. Test Activation

When the unit is triggered on one of the inputs A, B or C the display will show "-ON-" throughout
the procedure. This test option allows you to test trigger one of the three inputs A, B or C. In
the test mode the display will show the unit's actions.
The following example shows how to simulate a trigger on input A. The Acknowledgement
option is set to "CLEARED BY ANY 1" (see page 7).
Ensure that the SD1 is
initialise and the display
shows "READY".
Dialling telephone No.1
Telephone is ringing
Message A is played
Dialling telephone No.2
Telephone is ringing
Message A is played
Dialling telephone No.3
Telephone is ringing
Message A is played
Page 6
READY
Press the A key then the [ key
SENDING A TO NO 1
RINGING
PLAYING PHRASE 0
PLAYING PHRASE A
No reply or no
NO REPLY
SENDING A TO NO 2
RINGING
PLAYING PHRASE 0
PLAYING PHRASE A
No reply or no
NO REPLY
SENDING A TO NO 3
RINGING
PLAYING PHRASE 0
PLAYING PHRASE A
No reply or no
NO REPLY
Test calls may be
cancelled at any time
by pressing the ] key.
CALL SUCCESSFUL
Call acknowledged
CALL SUCCESSFUL
Call acknowledged
CALL SUCCESSFUL
Call acknowledged
Repeat from telephone No.1
(will attempt each No. 3 times.)