Recording Messages - Menvier Security SD1 Operating Instructions Manual

Programming Telephone Numbers (Cont.)
When the SD1 dials a telephone number it will automatically select the correct dialling
format. In the U.K. there are two formats:
Pulse Dialling: This is the older format and is sometimes referred to as Loop Disconnect/LD.
Tone Dialling: This is the modern format and sometimes referred to as Multiple
Frequency/MF.
Any or all of the telephone numbers can be selected to override the automatic format
selection and be forced into dialling the number in one of the above formats if required.
Before entering the telephone number in the procedure, press the B key to select "Pulse
Dialling" ( ) or press the C key to select "Tone Dialling" ( )

4. Recording Messages

The SD1 can record four phrases A, B, C and a common phrase 0. Each can be up to eight
seconds long and the four phrases are used to form three messages A, B and C:
Message A = phrase 0 + phrase A.
Message B = phrase 0 + phrase B.
Message C = phrase 0 + phrase C.
Phrase 0 is normally used to store the name and address of the premises, whereas phrases A,
B and C is normally used to store the type of alarm condition, e.g.,
Phrase 0: "This Is Mr Smith, at 10 The Strand, East Fincham"
Phrase A: "There is a Fire Alarm condition, there is a Fire Alarm condition"
Phrase B: "There is a Personal Attack Alarm, there is a Personal Attack Alarm"
Phrase C: "There is an Intruder Alarm condition, there is an Intruder Alarm condition"
Before you record phrases it is advisable to prepare them first by writing them down. The
following example shows how to record the common phrase 0:
Ensure that the SD1 is initialised and the
display is showing "READY"
Pressing the 0, A, B or C key, selects
phrases 0, A, B, or C.
Stand back about 6-8 inches from the unit.
When ready press the [ key to start
recording, speak clearly into the unit. The
display will count down the remaining time in
seconds. If the phrase is less than eight
seconds you can press the ] key to end the
recording.
Repeat for phases A, B and C, as required.
SD1 Operating Instructions
READY
Press the [ key
ENTER 1-3 OR 0-C
Select Phrase 0, A, B or C
(e.g., Press 0 )
RECORD PHRASE 0
Press the [ key to
start recording
RECORDING-8
RECORDING-0
Page 3