Table of Contents
Advertisement
B
Stream Settings (continued)
Multicast Port
C
Operator Password
D
Cancel
E
OK
:
Memo
● To use Built-in MPEG4 Viewer of VN-V686WPU, install "ffdshow" that is open source codec. You can
download "ffdshow" from the Internet.
● The settings of Built-in Viewer are stored in the file named Cookie.
This setting screen is used to set Built-in Viewer as a software on the computer, and does not apply to
settings of the VN-V686WPU unit.
When settings are changed, press the [OK] button to exit and restart the viewer.
Searching and deleting cookie files
● Open [Tool]-[Internet Options]-[Advanced] of the Internet Explorer, and press the [Settings] button under
[Temporary Internet Files]. A new [Settings] will appear. Press the [View Files] button in this window. The
[Temporary Internet Files] window opens up and a list of files will be displayed. The file named cgi-bin in
this list is the Cookie for Built-in Viewer.
● Deleting this file deletes the view settings, and the viewer will be initialized during the next startup.
You can change the multicast port number.
The default port number setting is 59152.
:
Memo
● This is enabled when Start is selected for the [JPEG Control] item on
the [Streaming] page.
● Specify the same value as the parameter that is set on the [Streaming]
page of VN-V686WPU. (A Page 71)
Operator password is required to control VN-V686WPU and to get preset
position title from VN-V686WPU. To use PTZ Controller or to display
preset position title, enter operator password.
[Enter user name and password] (A Page 34)
When the operator password has been entered under other settings, it
will be displayed as ●●●●●●.
Cancels the changed settings and closes the setting screen.
Saves the changed settings.
Click the [OK] button to enable the new settings and restart Built-in
viewer after closing the setting window.
Advertisement
Table of Contents
