Lan Cable Connection; Video Signal Output Terminal Connection - JVC VN-C20 Instructions Manual

Connection / Installation

LAN Cable Connection

Connect the camera to a hub or computer using
a LAN cable.
Use the shielded cable for connections.
When connecting to a hub
Make use of a straight cable.
When connecting to a computer
Make use of a Cross Over cable.
1 2
POWER VIDEO OUT
CAUTION: Do not use
PoE and AC24V together
Caution:
● However, cross cables cannot be used with
some computer models. When connecting
VN-C20 directly to a computer, make sure to
check the computer's LAN specifications in
advance.
Note:
● Make use of a Category 5 (or higher) cable in
the case of 100BASE-TX.
16
G 2 2
1 1
ALARM
PUSH
10BASE-T/100BASE-TX
DO NOT CONNECT TO THE
TELEPHONE NETWORK
For USA
Video Signal Output
Terminal Connection
Connect to a video monitor, etc. using a coaxial
cable.
1 2
POWER VIDEO OUT
CAUTION: Do not use
PoE and AC24V together
Note:
● The video output signal is NTSC.
Video signal cable (coaxial cable)
● See below for the connection
distance.(Reference value)
Maximum 200
extension (m)
Cable to use RG-59
Caution:
● A longer cable extension distance causes
signals to be attenuated, images to
deteriorate and noise to increase.
G 2 1 2 1
ALARM
PUSH
10BASE-T/100BASE-TX
DO NOT CONNECT TO THE
TELEPHONE NETWORK
For USA
350 450
RG-6 RG-11