Table of Contents
Advertisement
3.
Perform area setting.
Image of the position that is selected as the Fixed area in
Notes
● The area display position only serves as a guide. Ensure to perform operation check.
● Each screen is divided into 300 (20x15) blocks. Adjust the zoom ratio of the lens such that the
object for which motion is to be detected is at least the size of multiple blocks.
Cautions
● Flickering lights may cause false detections in motion when the camera is connected.
● When brightness varies due to the use of the auto iris function or lighting conditions, this may
be detected as motion. In this case, it is recommended that the detection time be set to a
value other than "0".
● When automatic control is enabled, false detection may occur at the instant when the camera
starts to move. In this case, it is recommended that the detection time be set to a value other
than "0".
● Note that the motion detection function is not designed to prevent theft or fire. It may not
function properly under certain object or setting conditions. We shall not be responsible for
any accident or losses incurred.
2
2
of Step
1
Click and drag the mouse to select the
detection area. To cancel the detection area
(displayed in yellow), right-click and drag the
mouse.
Area for which motion is detected will be
displayed in red.
2
For setting the sensitivity level of motion
detection.
Drag towards the right to increase and left
to decrease the sensitivity level.
Upon clicking
1
selected in
will be selected as the motion
detection area and displayed in yellow.
will be displayed.
, area other than that
47
Advertisement
Table of Contents
