Connection Of Lan Cables - JVC V.NETWORKS VN-C625 Instructions Manual

Jvc dome type network camera instructions
Hide thumbs Also See for V.NETWORKS VN-C625:
Table of Contents

Advertisement

Alarm Output Terminal
VN-C625
OUT
Terminal
Grounding
Terminal
(Alarm Output
Equivalent Circuit)

3. Connection of LAN Cables

Note
When using 100 BASE-TX, ensure to use a Category 5 (or higher) cable.
Alarm Device
Connection
Example
DC 12 V
R
IN
GND
Connect this terminal to alarm devices such
as an annunciator, indicator, lamp or buzzer.
Output Requirements
• Equivalent to NPN open collector output (Set
output logic using the controller)
• Allowed applied voltage: DC12V and below
• Allowed input current: 50 mA
• Momentary output: 1 to 5000ms (Set duration
using the controller)
Caution
Connect the grounding terminal of VN-C625
to the GND terminal of the alarm device.
Use the LAN cable to connect this camera
to a hub or PC
When connecting to a hub
make use of a straight cable.
When connecting to a PC
make use of a cross cable.
Caution
The use of a cross cable may not be
supported by certain LAN boards on some
rare occasions. As such, please check your
LAN board specifications before connection.
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

V.networks vn-c625uVc vn-c625

Table of Contents